4-8 (8) 2UEA001270 Rev. F ACS2000 User manual
Chapter 4 - Transportation, storage and disposal
4.3 Storage and handling instructions for spare parts
Static electricity can damage printed circuit boards.
Apply static-sensitive precautions when handling these components.
Inspect the spare parts immediately after receipt for damages. Report any
damage to the shipping company and the ABB service organization.
Observe the following to maintain spare parts in good condition and to
keep the warranty valid during the warranty period:
• Keep spare parts in their original packaging.
• Store printed circuit boards in antistatic bags or boxes.
• Storage temperature range: -5 °C to + 55 °C [23 °F to 131 °F]
• Storage place requirements:
• Free of vibration and shock.
• Protected against dust, sand, vermin and insects.
• Free of corrosive gases, salt or other impurities that could
damage electronic equipment.
• Dry; no condensation
Relative air humidity: 5 to 85%
If in doubt whether the maximum allowed humidity may be
exceeded, protect the spare parts with an external heater.
• Apply static-sensitive precautions when handling printed circuit
boards. Static electricity can damage these components.
• Do not touch a component without wearing a wrist grounding
strap.
• Put the component on a grounded working surface, protected
against electrostatic discharges.
• Hold the component only at the edge.
4.4 Disposal of packaging materials and components
Dispose of the packaging materials and the components at the end of the
lifetime of the drive according to local regulations.
To Next Page
Loading...
