ACS2000 User manual 2UEA001270 Rev. F 4-5 (8)
Chapter 4 - Transportation, storage and disposal
• Considering the drive cabinet length, use forks of sufficient length to
ensure stable transportation and to prevent tipping.
• Take care not to damage the cabinet.
• Be careful when transporting to avoid tipping.
Note: The lifting brackets (see 2, in Figure 4-3) are not used in this
transportation method and can be removed.
See Appendix D - Mechanical drawings, located on the CD, for
specific information on the dimensions and weight of the cabinet.
4.2 Storage
4.2.1 Storage conditions
The minimum requirements for storage are based on IEC 60721-3-1
“Classification of environmental conditions: Classification of groups of
environmental parameters and their severities; Storage”.
Classification: 1K4 / 1Z3 / 1B1 / 1M3
See Appendix C - Technical data/environment/operation, located on the
CD, for detailed information.
The drive can be stored for up to one year in the original packaging as long
as it is not damaged or opened. For information on longer storage periods
contact the ABB service organization.
4.2.2 Storage
If the drive is taken out of service for an extended period of time, proceed
as follows:
1 Cover all cable inlets and ventilation slots with an impermeable plastic
or aluminum foil and a wooden panel.
2 Put a 0.5 kilogram [1 lb] bag of desiccant inside each of the two
lockable compartments. (See Figure 4-4 - Frame 1, Figure 4-4 -
Frame 2 or Figure 4-4 - Frame 3.)
3 Attach a humidity sensor tab inside each of the two lockable
compartments. (See Figure 4-4 - Frame 1, Figure 4-4 - Frame 2 or
Figure 4-4 - Frame 3.)
4 Close and lock the doors of the cabinet.
To Next Page
Loading...
