ACS2000 User manual 2UEA001270 Rev. F 8-11 (18)
Chapter 8 - Local operation
8.6 Stopping
Press the stop key on the CDP control panel.
The motor stops according to the preset stop function and the drive stops
modulating. While the motor stops, the status line of the display shows
ReadyRef. The run status indication blinks during the stop sequence.
As long as the stop sequence is in progress, the drive can always be
restarted by pressing the start key on the CDP control panel.
6 Start the motor. Press the start key on the CDP control panel.
After the motor has been magnetized, the motor speed ramps up to
the setpoint.
While the motor is accelerating, the run status indication on the
display blinks. When the motor speed has reached the setpoint, the
run status indication lights up steady.
The display shows ReadyRef to indicate that the drive system is
operating.
1 L ->
600.0 rpm
StateINU
ReadyRef
MOTOR SP 300.00 rpm
POWER
1000.0 kW
1 L ->
600.0 rpm
StateINU
ReadyRef
MOTOR SP 300.00 rpm
POWER
20.0 kW
To Next Page
Loading...
