5-10 (14) 2UEA001270 Rev. F ACS2000 User manual
Chapter 5 - Mechanical installation
5.4.5 Redundant fan installation and removal procedures - Frames 2, 3 (option)
The redundant fan unit and the required fastening screws are supplied
separately.
Figure 5-5 - Frames 2, 3 Redundant fan unit (Frame 2 pictured)
Tools • Torx screwdriver for removing/installing the side panels of the fan or
10 mm hex wrench to install the hexagon fastening hardware.
• See Appendix D - Mechanical drawings, located on the CD, for
specific information on the dimensions and weight of the drive.
Wiring connections will need to be made. Make sure no power is
connected to the drive before proceeding with redundant fan installation.
To Next Page
Loading...
