9-4 (24) 2UEA001270 Rev. F ACS2000 User manual
Chapter 9 - CDP control panel
9.3.2 Actual signal display mode
9.3.2.1 Overview
Two kinds of displays can be selected in the actual signal display mode:
• Actual signal display
• Fault history display
The actual signal display appears first when the actual signal display
mode has been selected. However, when the drive is in a fault condition,
the fault display will be shown instead.
The actual signal display is used to monitor the drive without interfering
in its operation. Three selectable actual values are shown continuously on
the display.
The CDP control panel will automatically return to the actual signal
display mode from other modes within one minute when no keys are
pressed (exceptions: status display and common reference display
when in drive selection and fault display mode).
Actual values
See Appendix M - Signal and parameter table, located on the CD, for the
complete list of selectable actual signals.
Group 01 - Measured or calculated motor values
Group 02 - Measured or calculated drive values
Group 03 - Reference values
Group 04 - Status signals of IOEC I/O system
Group 05 - Communication link and
MV switchgear status signals
Group 06 - Software version, drive
and motor nominal values
Group 07 - Control words
Group 08 - Status words
Group 09 - Fault and alarm words
To Next Page
Loading...
