ABB ACS2000 - Energizing the Drive

8-12 (18) 2UEA001270 Rev. F ACS2000 User manual
Chapter 8 - Local operation
Just before the motor comes to a standstill, the CDP control panel briefly
displays the message Stopping.
When the drive has stopped modulating, the CDP control panel displays
ReadyRun.
As long as the MV switchgear has not been opened, the motor can be
started again.
8.7 De-energizing the drive
DANGER
Hazardous voltage!
Do not try to gain access to the medium voltage compartments of the
drive, or the motor, as long as the drive system is energized and
ungrounded.
Note: For drives with the integral input contactor disconnect option
installed, refer to Appendix P for detailed information as some
compartments such as TEU are still live after disconnect is opened.
1 L ->
600.0 rpm 0
StateINU
Stopping
MOTOR SP 0.00 rpm
POWER
0.0 kW
1 L ->
600.0 rpm 0
StateINU
ReadyRun
MOTOR SP 0.00 rpm
POWER
0.0 kW