9-20 (24) 2UEA001270 Rev. F ACS2000 User manual
Chapter 9 - CDP control panel
9.4 Operational commands
9.4.1 Local remote control location
The local/remote feature of the CDP
control panel allows the operator to select
the control location of the drive:
• Local control
• Remote control
The control location is selected by
pressing the LOC / REM key on the CDP
control panel.
9.4.1.1 Local control
When the CDP control panel is switched to local, operation via the
pushbuttons on the control compartment door and the CDP control panel
is possible. Control commands from remote have no effect. Local can only
be selected when the drive has been stopped and no remote run
command is active. Switching from local to remote while the drive is
running will stop the drive.
9.4.1.2 Remote control
When the CDP control panel is switched to remote, the pushbuttons on
on the control compartment door and the operational keys of the CDP
control panel are disabled. Operational commands and reference values
from a remote control station are transmitted via fieldbus or remote I/O to
the drive. Switching from remote to local while the drive is running is not
possible.
9.4.1.3 Selecting local and remote
1 To select local control,
press the LOC / REM
key. The local control
location is indicated by
the letter L.
1 L
600.0 rpm
StateINU
MOTOR SP
POWER
ReadyRun
0.00 rpm
0.0 kW
0
Local control location
To Next Page
Loading...
