ABB ACS2000 - Figure 5-8 - Frame

ACS2000 User manual 2UEA001270 Rev. F 5-9 (14)
Chapter 5 - Mechanical installation
Figure 5-8 - Frame 1 Redundant fan power supply connections
6 Bolt the fan inlet ring to the top of the drive.
Figure 5-9 - Frame 1 Inlet ring installation
7 Install the fan in the fan box.
Figure 5-10 - Frame 1 Fan installation
8 Route the fan wires (see Figure 5-10 - Frame 1) and connect to the
terminal block.
9 Check that the flapper is moving freely.
10 Reattach the front panel and the cover of the fan unit.
100(U1)
W12210 W12211 W12212
107(TK2) 101(V1)
102(W1)
PE
W122PE2
103(U2) 104(V2)
105(W2)
106(TK1)
Legend
1 Terminal block X22
2 Wire numbers
3 Redundant fan
power supply
1
3
2
Legend
1 Fan inlet ring
1
Legend
1 Fan
2 Fan wires
3 Terminal block
3
1
2