6-14 (16) 2UEA001270 Rev. F ACS2000 User manual
Chapter 6 - Electrical installation
Fuse specifications The power fuses are specified in Table 6-3.
Table 6-3 Power fuse ratings
See Appendix P - Integral input contactor disconnect, located on the CD,
for fuse location on drives with this option.
6.6.3.5 Final checks
Check that the entry plates are properly fastened.
If rubber grommets are used, check that they fit tightly to prevent water
from entering the cabinet. If necessary, seal the gaps with silicone rubber.
6.7 Auxiliary power, control and fieldbus communication cables
6.7.1 Further information
See Layout drawing in Appendix D - Mechanical drawings, located on the
CD, for information on:
• Project specific cable entry
• Dimensions between point of cable entry and terminals
See Appendix E - Wiring diagrams, located on the CD, for information on:
• Designation, cross-reference and device-identification conventions
Drive rating
kW [hp]
Current rating
(A)
ABB
part number
Quantity
per phase
Frame 1
224-298 [300-400] 80 2UEA001267 1
336-522 [450-700] 140 2UEA001268 1
597-746 [800-1000] 200 2UEA000093 1
Frame 2
933 [1250] 140 2UEA001268 2
1119-1492 [1500-2000] 160 2UEA002203 2
Frame 3
1679-2238 [2250-3000] 230 2UEA001947 2
To Next Page
Loading...
