ABB ACS2000 - Identification Mode

ACS2000 User manual 2UEA001270 Rev. F 9-3 (24)
Chapter 9 - CDP control panel
9.3.1 Identification mode
When the power supply is switched on, or the CDP control panel is
connected to the drive and the auxiliary voltage has been switched on
already, the identification display appears showing the CDP control
panel version and then the ID-number of the drive. When the CDP control
panel is initialized, the display changes as follows:
Display when
initialized
After 2-3 seconds,
information on drive
(1, 2), the application
software in use (3),
and the drive
identification (4) is
displayed.
After another few
seconds
After another few
seconds, the display
changes to the actual
signal display mode.
The status line of the
display alternates
between
DCGndNopen,
NotReadyOn.
CDP312 PANEL V5.30
........
ACS2000 xxxx
< Device Name >
ID-NUMBER 1
LDAI55xxC
1
2
3
4
1 L ->
0.0 rpm
StateINU
InitSeq....
MOTOR SP 0.00 rpm
POWER
0.0 kW
1 L ->
0.0 rpm
StateINU
DCGndNopen
MOTOR SP 0.00 rpm
POWER
0.0 kW
DCGndNopen
NotReadyOn