ACS2000 User manual 2UEA001270 Rev. F 5-1 (14)
Chapter 5 - Mechanical installation
5.1 Safety
All mechanical installation work must be carried out by qualified personnel
according to the site and equipment requirements and in compliance with
local regulations.
See Chapter 1 - Safety, for information on how the safety messages are
categorized and used in this manual.
5.2 Overview of installation procedure
Installation includes:
• Preparing the foundation
See section 5.3.2 Foundation requirements.
• Mounting the drive to the floor
See section 5.4.3 Base mounting.
• Installing the fan outlet box
See section 5.4.4 Fan outlet box installation - Frame 1 (if required) or
5.4.4 Fan outlet box and external fan installation - Frames 2, 3 (if
required).
• Installing the optional redundant fan
See section 5.4.5 Redundant fan installation - Frame 1 (option) or
5.4.5 Redundant fan installation and removal procedures - Frames 2,
3 (option).
5.3 Installation site requirements
5.3.1 Ambient operation conditions
Ambient factors such as temperature, relative humidity, air contamination,
shock and vibration must be in compliance with the stated maximum
permissible levels.
Contact the ABB service organization if the condition of the installation site
is not within the specifications or if the transportation or the installation
require special measures.
• Maximum ambient temperature: see the drive rating label located on
the back of the control compartment door
• Operation with respect to climatic and environmental conditions is
based on IEC 60721-3-3
Classification: 3K3 / 3B1 / 3C2 / 3S2 / 3M3
To Next Page
Loading...
