ABB ACS2000 - Cable Connection

ACS2000 User manual 2UEA001270 Rev. F 6-11 (16)
Chapter 6 - Electrical installation
6.6.3 Cable connection
6.6.3.1 Cable lugs
Mount cable lugs suitable for M12 or 0.5 inch bolts. Cables must be
terminated with lugs according to the specification of the cable
manufacturer.
6.6.3.2 Busbars
Connect the cables to their corresponding busbars.
Figure 6-8 Busbars
• Connect the line supply cable conductors to busbars L1, L2, L3
• Connect the motor cables to busbars U2, V2, W2
• Connect the shielded ends of all conductors and the shield of all
cables to the PE (Protective Earth) ground bus (1 or 6 in Figure 6-8)
• Connect the ground cable to the PE ground bus (1 or 6 in Figure 6-8)
1
Legend
1 PE ground bus
2 Power OUT
3 Power IN
4 Fuses
5 Strain relief
2
U2
V2
W2
3
L1
L2
L3
4
5