ACS2000 User manual 2UEA001270 Rev. F 10-21 (32)
Chapter 10 - Troubleshooting and maintenance
10.4.7.1 Filter mat replacement procedure
Filters can be replaced while the drive is running, as they are accessable
from the outside. Caution should be made not to shake filter in front of
drive to avoid sucking contaminents into the drive.
While filter grills are finger safe, be aware that components on the inside
may be electrically live and action should be taken to avoid contact with
tools or fingers.
1 Remove the ventilation grill of the
corresponding section.
The ventilation grills are secured to the cabinet by a
channel.
Lift the grill to the slot position and remove.
2 Visually check the filter mat If the filter mat needs replacement, go on to Step 3. If
the mat is clean, replace the grill as in Step 5.
3 Remove the filter mat Remove the filter mat, being careful not to disturb
accumulated dust, by rolling the mat down from the top
to the bottom.
To Next Page
Loading...
