114 Electrical installation
Terminals L1, L2 and L3
• Remove the combi screw that attaches the connector to its terminal post, and
pull the connector off.
• Put the conductor under the connector pressure plate and pre-tighten the
conductor.
• Put the connector back onto the terminal post. Start the combi screw, and turn
it at least two rotations by hand.
WARNING! Before using tools, make sure that the nut/screw is not cross-
threading. Cross-threading will damage the drive and cause danger.
• Tighten the combi screw to a torque of 30 N·m (22 lbf·ft).
• Tighten the conductor(s) to 40 N·m (30 lbf·ft) for frame R8 or to 70 N·m
(52 lbf·ft) for frame R9.
11. Frames R8…R9
: If you install parallel cables, install the second grounding shelf
for the parallel power cables (11a). Repeat steps 6...11 (11b).
12. Install the grounding shelf of the control cables.
M5×25
M5×12
11a
11b
11a
11b
R8…R9 R8…R9
To Next Page
Loading...
