ABB IRB 1200 - Page 109

The O-ring specified below is delivered together with the robot and must be installed
to the main power connector during electrical installation.
NoteArt. no.Equipment
For robots with protection class IP673HAB3772-19O-ring
For robots with protection type Foundry
Plus
For robots with protection type Clean
Room
For robots with food grade lubrication
For robots with protection type Hygienic
Used to seal between the main power
cable and the connector.
Robots with manipulator cables routed
from the rear of the base:
xx1500000243
Robots with manipulator cables routed
from below (option 996-1):
xx1500000242
Customer cables - CP/CS cable (option)
The following table lists the CP/CS cables for connecting IRC5/IRC5C controller.
Article numberCP/CS cable length
3HAC049089-0013 m (IRC5)
3HAC049089-0047 m (IRC5)
3HAC049089-00515 m (IRC5)
3HAC049089-00622 m (IRC5)
3HAC049089-00730 m (IRC5)
3HAC049186-0013 m (IRC5C)
3HAC049186-0047 m (IRC5C)
3HAC049186-00515 m (IRC5C)
Continues on next page
Product manual - IRB 1200 109
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
2 Installation and commissioning
2.7.1 Robot cabling and connection points
Continued