ABB IRB 1200 - Restricting the Working Range; Axes with Restricted Working Range

2.5 Restricting the working range
2.5.1 Axes with restricted working range
General
When installing the robot, make sure that it can move freely within its entire working
space. If there is a risk that it may collide with other objects, its working space
should be limited.
The working range of the following axes may be restricted:
• Axis 1, hardware (mechanical stop) and software. Note! The axis 1 stop is a
fixed stop that must be installed during operation of robot!
• Axis 2, hardware (mechanical stop) and software. Note! The axis 2 stop is a
fixed stop that must be installed during operation of robot!
• Axis 3, hardware (mechanical stop) and software. Note! The axis 3 stop is a
fixed stop that must be installed during operation of robot!
• Axis 4, hardware (mechanical stop) and software. Note! The axis 4 stop is a
fixed stop that must be installed during operation of robot!
• Axis 5, hardware (mechanical stop) and software
• Axis 6, software
This section describes how to install hardware that restricts the working range.
Note
Adjustments must also be made in the robot configuration software (system
parameters). References to relevant manuals are included in the installation
procedures.
Product manual - IRB 1200 99
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Axes with restricted working range