3.5.2 Cleaning the IRB 1200 with protection type Hygienic
Overview
Hygienic robots are designed with special sealings and coatings. The axis-6 tool
flange is also equipped with stainless steel sealing set. These special designs
allow the Hygienic robots to be wiped down or washed down using corresponding
proper detergents according to actual working environments and applications.
Cleaning methods also vary according to the to-be-cleaned surfaces and parts of
the IRB 1200 with protection type Hygienic. Always use the proper cleaning method
according to the actual applications and strictly follow the cleaning procedure.
xx2100001401
User toolsA
The robot body without any protection should use
the wipe down method for cleaning. If the robot
body is properly covered by protective device or
equipment, the wash down method is also applic-
able.
Wipe down areaB
In most cases, the tool flange surface should use
the wash down method for cleaning. Users can
also perform wipe down cleaning on this part ac-
cording to their applications.
Wash down areaC
Continues on next page
152 Product manual - IRB 1200
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
3 Maintenance
3.5.2 Cleaning the IRB 1200 with protection type Hygienic
To Next Page
Loading...
