Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the IRB 1200 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC045759-001EIB unit
Used for IRB 1200 Type B. See
Type B of IRB 1200 on page 873.
3HAC059122-001SMB unit
Not used with protection class
IP40.
Replace if damaged.
3HAC056728-001 /
3HAC080706-001
Gasket on EIB/SMB cover
Not used with protection class
IP40.
Replace if damaged.
3HAC056724-001 /
3HAC080702-001
Gasket on cable housing cover
Required tools and equipment
NoteArticle numberEquipment, etc.
Used to release the motor brakes.-24 VDC power supply
Content is defined in section Standard
toolkit on page 890.
-Standard toolkit
Required consumables
NoteArticle numberEquipment
Loctite 2433HAB7116-1Locking liquid
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
NoteAction
Note
Calibrating axis 6 always requires tools to
be removed from the mounting flange (also
for reference calibration) since the mount-
ing flange is used for installation of the
calibration tool.
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
1
Continues on next page
292 Product manual - IRB 1200
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.3.4 Replacing the EIB/SMB unit
Continued
To Next Page
Loading...
