Required tools and equipment
NoteArticle numberEquipment, etc.
Used to release the motor brakes.-24 VDC power supply
Content is defined in section Standard
toolkit on page 890.
-Standard toolkit
Replacing the mechanical stop
Use these procedures to remove the axis-2 mechanical stop.
Preparations before removing the mechanical stop
NoteAction
Jog the robot to a position where the
mechanical stop is most easily accessed.
1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
2
CAUTION
For robots with protection type Clean
Room
For robots with food grade lubrication
For robots with protection type Hygienic
Always cut the paint with a knife and grind
the paint edge when disassembling parts
of the robot! See Cut the paint or surface
on the robot before replacing parts on
page 158.
3
Replacing the axis-2 mechanical stop
NoteAction
DANGER
Make sure that all supplies for electrical
power, hydraulic pressure, and air pressure
are turned off.
1
Continues on next page
Product manual - IRB 1200 455
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.4.5 Replacing the axis-2 mechanical stop
Continued
To Next Page
Loading...
