Inspecting the oil level in axis-4 gearbox
Use this procedure to inspect the oil level in the gearbox.
NoteAction
Floor-mounted robot:1
Run the robot to calibration position.
Option Inverted (3317-1)2
Jog the robot into position:
• Axis 1: no significance
• Axis 2: 0°
• Axis 3: -180°
• Axis 4: no significance
• Axis 5: no significance
• Axis 6: no significance
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safe-
guarded space.
3
Make sure that the oil temperature is +25°C
± 10°C.
4
WARNING
Handling gearbox oil involves several
safety risks, see Gearbox lubricants (oil or
grease) on page 29.
5
xx2100002072
Open the oil plug.6
Check the oil level.7
Required oil level is: 0-10 mm below oil
plug hole
Continues on next page
132 Product manual - IRB 5720
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
4 Maintenance
4.3.9 Inspecting the oil level in axis-4 gearbox
Continued
To Next Page
Loading...
