• Do not use solvents that are not approved by ABB to clean the robot.
• Do not spray from a distance closer than 0.4 m.
• Do not remove any covers or other protective devices before cleaning the
robot.
Cleaning methods
This following table defines what cleaning methods are allowed for ABB
manipulators depending on the protection type.
Cleaning methodProtection
type
High pressure water or
steam
Rinse with waterWipe with clothVacuum
cleaner
NoYes. It's highly re-
commended to in-
spect the fans for
contamination that
could hinder the air
supply at the regu-
lar cleaning, and
then clean if neces-
sary.
Yes. With light
cleaning deter-
gent.
YesStandard
Yes
i
.Yes. It is highly re-
commended that
the water contains
a rust-prevention
solution.
Yes. With light
cleaning deter-
gent or spirit.
YesFoundry Plus
It is highly recommended
that the water and steam
contains rust preventive,
without cleaning deter-
gents.
i
Perform according to section Cleaning with water and steam on page 184.
Cleaning with water and steam
Instructions for rinsing with water
ABB robots with protection types Standard, Foundry Plus, Wash, or Foundry Prime
can be cleaned by rinsing with water (water cleaner).
1
The following list defines the prerequisites:
• Maximum water pressure at the nozzle: 700 kN/m
2
(7 bar)
I
• Fan jet nozzle should be used, min. 45° spread
• Minimum distance from nozzle to encapsulation: 0.4 meters
• Maximum flow: 20 liters/min
I
I
Typical tap water pressure and flow
Instructions for steam or high pressure water cleaning
ABB robots with protection types Foundry Plus, Wash, or Foundry Prime can be
cleaned using a steam cleaner or high pressure water cleaner.
2
The following list defines the prerequisites:
• Maximum water pressure at the nozzle: 2500 kN/m
2
(25 bar)
• Fan jet nozzle should be used, min. 45° spread
• Minimum distance from nozzle to encapsulation: 0.4 meters
1
See Cleaning methods on page 184 for exceptions.
2
See Cleaning methods on page 184 for exceptions.
Continues on next page
184 Product manual - IRB 5720
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
4 Maintenance
4.5.1 Cleaning the IRB 5720
Continued
To Next Page
Loading...
