NoteAction
Rotation tool: 3HAB7887-1Apply the rotation tool.6
Use caution and fit the motor in its final
position while at the same time rotating the
motor pinion slightly using the rotation tool.
• Make sure that the motor pinion is
properly mated to the gear of the
gearbox.
• Make sure that the motor pinion
does not get damaged.
• Make sure that the direction of the
cable exit is facing the correct way.
Hex socket head cap screw: M10x30 12.9
Gleitmo 603+Geomet 500 (2 pcs)
Fit two of the attachment screws and
washers.
7
Bits extender: 3HAC12342-1
xx2100002212
Use a bits extender in order to reach the
screws.
Continues on next page
380 Product manual - IRB 5720
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.8.4 Replacing the axis-4 motor
Continued
To Next Page
Loading...
