ABB OmniCore C90XT - Page 126

Note/IllustrationAction
xx1900001879
Pull the cable ties out from the locking
holes.
2
xx1900001880
Remove the screws and lift out the robot
signal exchange proxy.
3
Installing the DeviceNet board
Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
xx2000000419
Continues on next page
126 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.6 Installing the fieldbus master
Continued