ABB OmniCore C90XT - Page 133

Note/IllustrationAction
For the main computer:
• A2.X3 - X24
• K2.X8 - A2.X6
• K2.X2 - K4.X8, A2.X1
• K2.X12 - A2.K3.X6, A2.K3.X7
• K6.X2 - A2.X9
• A2.X5 - K7.X2
• A2.X4 - K4.X6/K5.1.X5
Note
If the Ethernet extension switch is
installed, connect and disconnect
the connector A2.X4 to/from
K4.X6.
If the Ethernet extension switch is
not installed, connect and discon-
nect the connector A2.X4 to/from
K5.1.X5.
i
For Connected Services Gateway wired, there is no power cable.
Concluding procedure
Note/IllustrationAction
Closing the door on page 174.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 165.
2
Product manual - OmniCore C90XT 133
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.7.6 Installing the fieldbus master
Continued