ABB OmniCore C90XT - Page 178

Removing the axis computer
Note/IllustrationAction
xx1900001487
Remove the bracket screws.1
Remove the axis computer.2
Refitting the axis computer
Refitting the axis computer
Note/IllustrationAction
Screws: Torx pan head screw M4x8 (4 pcs)Refit the axis computer to the bracket
and secure the screws.
1
xx1900001487
Refitting the axis computer to the frame
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
178 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.2 Replacing the axis computer
Continued