Removing the robot signal exchange proxy
Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
xx2000000419
xx1900001879
Pull the cable ties out from the locking
holes.
2
xx1900001880
Remove the screws and lift out the robot
signal exchange proxy.
3
Continues on next page
Product manual - OmniCore C90XT 269
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.2.12 Replacing the fieldbus master
Continued
To Next Page
Loading...
