ABB OmniCore C90XT - Page 290

Removing the manipulator signal connector
Note/IllustrationAction
xx1900001914
Loosen the screw and disconnect:
• SMB - K6.X4, K6.X5
1
xx1900001915
Remove the attachment screws on the
cover.
2
Push the manipulator signal connector
into the cabinet.
3
Take the manipulator signal connector
out.
4
Refitting the manipulator signal connector
Refitting the manipulator signal connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
290 Product manual - OmniCore C90XT
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the manipulator signal connector (SMB)
Continued