• Defining network settings on the FlexPendant:
1 On the start screen, tap Settings, and then select Network from the
menu.
2 Define IP address for the controller and tap OK.
PROFINET on factory network
When the WAN port is used for connecting to an industrial network, the traffic
shares the same media as the factory network and will share bandwith with other
non industrial network traffic.
The following figure illustrates the network when connecting a controller and a
device to the WAN port of the main computer:
Factory Network & Industrial Network
Private
Robot Controller 1
MGMT LAN1 LAN2 LAN3 WAN
PLC
Camera
Public
Cell I/O
I/OI/O
PROFINET
Private
Robot Controller 2
MGMT LAN1 LAN2 LAN3 WAN
Public
xx1900001102
Product manual - OmniCore C90XT 83
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Network connections on OmniCore
Continued
To Next Page
Loading...
