ABB PickMaster Twin - PowerPac - Page 338

Note/IllustrationAction
xx1900000477
Click on the Preview button to set the
preference of the conveyor.
11
Enter numbers (3000,300,500) in the LWH
Size(mm) text box to define the size of
the conveyor.
12
In the Conveyor window, enter numbers
(-1200,-200,0) in the Position X Y Z (mm)
text box and (0,0,0) in the Orientation
(deg) text boxes to define the location of
the conveyor.
13
Click OK to finish the adding of the con-
veyor.
14
xx1800000855
On the ribbon-tab, click Conveyor under
Layout.
15
xx1900000478
In the Conveyor window, enter "Linear2"
in the Conveyor Name text box.
16
In the Conveyor window, select the type
as "Linear" in the Conveyor Type drop-
down list.
17
xx1900000479
Click on the Preview button to set the
preference of the conveyor.
18
Enter numbers (3000,300,500) in the LWH
Size(mm) text box to define the size of
the conveyor.
19
In the Conveyor window, enter numbers
(-1200,-500,0) in the Position X Y Z (mm)
text box and (0,0,0) in the Orientation
(deg) text boxes to define the location of
the conveyor.
20
Click OK to finish the adding of the con-
veyor.
21
Adding the sensor
For detail procedure in adding the controller, see Adding the sensor on page 311.
Continues on next page
338 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
5 Production examples
5.3 Example: Mixing one pick work area and two place work areas
Continued