104 Start-up
Connecting DriveWindow
If the DriveWindow PC tool is used in the start-up procedure, proceed as follows.
Configuring the NETA-01 Ethernet adapter module
See NETA-01 Ethernet adapter module user’s manual (3AFE64605062 [English]).
Configuring the NETA-21 remote monitoring tool
See NETA-21 remote monitoring tool user’s manual (3AUA0000096939 [English]).
Connect the PC to the inverter in a ring as shown below:
Start the DriveWindow program and connect to the inverter by
choosing ABB.SMP OPC server.
Note: If all connected control units
are not seen through the optical ring,
check that the node address of each
RMIO board is set properly. Connect
optical fibers to channel CH3 in each
RMIO board and change parameter
70.15 CH3 NODE ADDR
accordingly.
Note: The new node address
becomes valid only after the next
power-up of the RMIO board.
Open the parameter window from the DriveWindow program.
RDCO
CH3:
RXD
TXD
RDCU A43
NDPA-0x
PC
RXD
TXD
NDPC-12
RDCO
CH3:
RXD
TXD
RDCU A41
RMIO
RMIO
PC
RUSB-02
USB port
RXD
TXD
or
To Next Page
Loading...
Need help?
General
