Safety instructions 19
Start-up and operation
These warnings are for all personnel who commission, plan the operation or operate the
inverter.
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur.
• Close the inverter AC and DC main switches and miniature DC circuit breakers (option
+H377) before start.
• Do not open the inverter AC or DC main switches or miniature DC circuit breakers
(option +H377) when the inverter is running.
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur.
• Before you adjust the inverter and put it into service, make sure that all equipment is
suitable for operation.
• The maximum allowed number of power-ups by applying power is five in ten minutes.
Note:
• If an external source for the start command is selected and it is ON, the inverter will
start immediately after a fault reset.
• When the control location is not set to Local (L not shown on the status row of the
display), the stop key on the control panel will not stop the inverter. To stop the inverter
using the control panel, press the LOC/REM key and then the stop key .
To Next Page
Loading...
Need help?
General
