16 Safety instructions
General safety
These instructions are for all personnel who install the inverter and do maintenance work
on it.
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur.
• Standard IEC/EN 62109-2 (section 4.8.3.6) requires that as the inverter is not provided
with full protection against shock hazard on the photovoltaic array, you must install and
use the inverter inside a closed electrical operating area.
• Handle the drive module carefully:
• Use safety shoes with a metal toe cap to avoid foot injury.
• Use extreme caution when manoeuvering an inverter or LCL filter module that
runs on wheels. Extend the support legs of the module when it is removed from
the cabinet! Do not tilt the module! The modules are heavy and have a high center
of gravity. They topple over easily if handled carelessly.
• Lift the module by the upper part only using the lifting hole(s) at the top!