ABB Remote I/O RIO600 - Trip Circuit Supervision TCSHSCBR;TCSLSCBR

Parameter name Range Unit Default value Description
Pulse length 10 to 65535 ms 10 The integer value in this
parameter indicates the
pulse length for the
output channels in ms.
Signal type
Static/Pulse Static Output signal type: static/
pulse
Output Channel 1
Enabled
Enabled/Disabled Enabled Output channel 1:
enabled/disabled
Output Channel 2
Enabled
Enabled/Disabled Enabled Output channel 2:
enabled/disabled
Output Channel 3
Enabled
Enabled/Disabled Enabled Output channel 3:
enabled/disabled
Output Channel 4
Enabled
Enabled/Disabled Enabled Output channel 4:
enabled/disabled
Output Channel 1
Inversion
Non-inverted/inverted Non-inverted Output channel 1: non-
inverted/inverted
Output Channel 2
Inversion
Non-inverted/inverted Non-inverted Output channel 2: non-
inverted/inverted
Output Channel 3
Inversion
Non-inverted/inverted Non-inverted Output channel 3: non-
inverted/inverted
Output Channel 4
Inversion
Non-inverted/inverted Non-inverted Output channel 4: non-
inverted/inverted
6.1.8.4 Trip circuit supervision TCSHSCBR/TCSLSCBR
Identification
Description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Trip circuit supervision TCSHSCBR/
TCSLSCBR
TCS TCM
Functionality
The trip circuit supervision function TCSHSCBR/TCSLSCBR supervises the control
circuit of the circuit breaker. The invalidity of a control circuit is detected by using a
dedicated input (Input 4) contact. The failure of a circuit is reported to the
corresponding function block in the IED configuration.
The operating time characteristic is according to the definite time (DT). The function
activate alarm after a predefined operating time and resets when the fault disappears.
Operation principle
The Operation setting is used to enable or disable the function. The corresponding
parameter values are “On” and “Off”.
The operation of TCSLSCBR can be described by using a module diagram. All
modules in the diagram are explained in the next sections.
1MRS757488 H Section 6
Commissioning
RIO600 165
Installation and Commissioning Manual