Table 102: FPIPTOC Technical data
Characteristic Value
Operation accuracy Depending on the frequency of the current
measured: f = f
n
±1.5% of the set value
Start time accuracy
±1.0% of the set value or ±70 ms
Operate time accuracy
1)
±1.0% of the set value or ±30 ms
1) f
n
= 50 Hz, results based on statistical distribution of 1000 measurements
6.1.7.8 Calibration
The SIM4F module is factory calibrated.
6.1.8 Operating parameter settings of SCM module
Smart control module can be configured for different applications. Application types
can be set during the configuration wizard operation. Because of solid state outputs,
the module allows a direct making, carrying and breaking of motor and coil currents.
This technical characteristic offers the capability to control three-position switches or
two-position switches of, for example, gas-insulated switchgears, which requires a so
called “4-4H bridge” in order to turn a DC motor in both directions.
6.1.8.1 Functions available in SCM
Table 103: Functions available in SCM
Function
IEC 61850 IEC 60617 IEC-ANSI
Edition 1 Edition 2
Supervision function
Trip circuit supervision TCSHSCBR/
TCSLSCBR
TCSHSCBR/
TCSLSCBR
TCS TCM
6.1.8.2 Three-position earthing switch or two-position earthing switch or two-
position disconnector switch or circuit breaker control application
The RIO600 smart control module is able to handle the following.
• Motor driven switches
• Three-position switch (combined earthing switch and disconnector switch)
• Two-position earthing switch
• Two-position disconnector switch
• Circuit breaker
• Interlocking rules to control coils
Each smart control module can handle one motor driven switch or one circuit breaker.
1MRS757488 H Section 6
Commissioning
RIO600 159
Installation and Commissioning Manual
To Next Page
Loading...
