ABB Remote I/O RIO600 - Configuration Examples

ABB
2
3
4
5
1
1
2
6
GUID-57402DEF-96C5-4555-9254-BD644C9D5B40 V2 EN
Figure 9: Assembly drawings of the RIO600 modules
1 Rubber cap
2 End clamp
3 PSM module
4 LECM module
5 DIM8H, DIM8L, DOM4, RTD4, AOM4, SIM8F, SIM4F, SCM8H, or SCM8L module
6 DIN rail
Disconnect the power supply to the module stack before any
configuration update, position change or during the addition or
removal of modules. The modules are not hot-swappable/pluggable.
Earthing of the used DIN rail should be arranged properly.
5.1.1 Configuration examples
The user-specific configuration can be adapted according to application requirements
by combining different modules.
RIO600 can be configured with a combination of low-voltage and high-voltage
modules, for example, PSMH-LECM-DIM8L, PSML-LECM-DIM8H or PSML-
PSMH-LECM-DIM8H-DIM8L-DOM4.
1MRS757488 H Section 5
Installing
RIO600 31
Installation and Commissioning Manual