ABB RET670 - Page 11

Setting parameters.....................................................................311
Faulty phase identification with load encroachment FMPSPDIS
(21)..................................................................................................311
Application..................................................................................312
Setting guidelines.......................................................................312
Setting parameters.....................................................................315
Distance protection zone, quadrilateral characteristic, separate
settings ZMRPDIS (21), ZMRAPDIS (21) and ZDRDIR (21D)........316
Application..................................................................................316
Setting guidelines.......................................................................332
Setting parameters.....................................................................339
Phase selection, quadrilateral characteristic with settable angle
FRPSPDIS (21)...............................................................................341
Application..................................................................................341
Load encroachment characteristics............................................347
Setting guidelines.......................................................................353
Setting parameters.....................................................................355
Power swing detection ZMRPSB (68).............................................356
Application..................................................................................356
Setting guidelines.......................................................................358
Setting parameters.....................................................................365
Power swing logic ZMRPSL ...........................................................366
Application..................................................................................366
Setting guidelines.......................................................................368
Setting parameters.....................................................................374
Pole slip protection PSPPPAM (78)................................................374
Application..................................................................................374
Setting guidelines.......................................................................377
Setting parameters.....................................................................389
Phase preference logic PPLPHIZ....................................................389
Application..................................................................................390
Setting guidelines.......................................................................393
Setting parameters.....................................................................395
Current protection.................................................................................395
Instantaneous phase overcurrent protection 3-phase output
PHPIOC (50)....................................................................................395
Application..................................................................................396
Setting guidelines.......................................................................396
Setting parameters.....................................................................401
Four step phase overcurrent protection OC4PTOC (51/67)............401
Table of contents
5
Application manual