ABB RET670 - About the Application Manual

The Technical Reference Manual (TRM) contains application and functionality
descriptions and it lists function blocks, logic diagrams, input and output signals,
setting parameters and technical data sorted per function. The technical reference
manual should be used as a technical reference during the engineering phase,
installation and commissioning phase, and during normal service.
The Installation and Commissioning Manual (ICM) contains instructions on how to
install and commission the protection IED. The manual can also be used as a reference
during periodic testing. The manual covers procedures for mechanical and electrical
installation, energizing and checking of external circuitry, setting and configuration as
well as verifying settings and performing directional tests. The chapters are organized
in the chronological order (indicated by chapter/section numbers) in which the
protection IED should be installed and commissioned.
The Operator’s Manual (OM) contains instructions on how to operate the protection
IED during normal service once it has been commissioned. The operator’s manual can
be used to find out how to handle disturbances or how to view calculated and measured
network data in order to determine the cause of a fault.
The Engineering Manual (EM) contains instructions on how to engineer the IEDs
using the different tools in PCM600. The manual provides instructions on how to set
up a PCM600 project and insert IEDs to the project structure. The manual also
recommends a sequence for engineering of protection and control functions, LHMI
functions as well as communication engineering for IEC 61850 and DNP3.
1.1.2 About the application manual
The application manual contains the following chapters:
• The chapter “Requirements” describes current and voltage transformer
requirements.
• The chapter “IED application” describes the use of the included software
functions in the IED. The chapter discusses application possibilities and gives
guidelines for calculating settings for a particular application.
• The chapter “Station communication“ describes the communication possibilities
in a SA-system.
• The chapter “Remote communication“ describes the remote end data
communication possibilities through binary signal transferring.
• The chapter “Configuration” describes the preconfiguration of the IED and its
complements.
• The chapter “Glossary” is a list of terms, acronyms and abbreviations used in
ABB technical documentation.
Section 1 1MRK504116-UUS C
Introduction
16
Application manual