ABB RET670 - Application; Setting Guidelines; Setting Parameters; Signal Matrix for Binary Inputs SMBI

3.4.8.1 Application
The rated system frequency is set under Main menu/General settings/ Power system/
Primary Values in the local HMI and PCM600 parameter setting tree.
3.4.8.2 Setting guidelines
Set the system rated frequency. Refer to section "Signal matrix for analog inputs
SMAI" for description on frequency tracking.
3.4.8.3 Setting parameters
Table 21: PRIMVAL Non group settings (basic)
Name Values (Range) Unit Step Default Description
Frequency 50.0 - 60.0 Hz 10.0 50.0 Rated system frequency
3.4.9 Signal matrix for binary inputs SMBI
3.4.9.1 Application
The Signal matrix for binary inputs function SMBI is used within the Application
Configuration tool in direct relation with the Signal Matrix tool. SMBI represents the
way binary inputs are brought in for one IED configuration.
3.4.9.2 Setting guidelines
There are no setting parameters for the Signal matrix for binary inputs SMBI available
to the user in Parameter Setting tool. However, the user shall give a name to SMBI
instance and the SMBI inputs, directly in the Application Configuration tool. These
names will define SMBI function in the Signal Matrix tool. The user defined name for
the input or output signal will also appear on the respective output or input signal.
3.4.9.3 Setting parameters
The function does not have any parameters available in local HMI or PCM600.
3.4.10 Signal matrix for binary outputs SMBO
Section 3 1MRK504116-UUS C
IED application
86
Application manual