EasyManua.ls Logo

ABB RET670 - Page 707

ABB RET670
888 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Name Values (Range) Unit Step Default Description
MeasMode A
B
C
AB
BC
CA
PosSeq
- - PosSeq Selection of measured voltage and current
Q1 -9999.99 - 9999.99 MVAr 0.01 0 Size of cap/reactor bank 1 in MVAr, >0 for C
and <0 for L
Q2 -9999.99 - 9999.99 MVAr 0.01 0 Size of cap/reactor bank 2 in MVAr, >0 for C
and <0 for L
Q3 -9999.99 - 9999.99 MVAr 0.01 0 Size of cap/reactor bank 3 in MVAr, >0 for C
and <0 for L
TotalBlock Disabled
Enabled
- - Disabled Total block of the voltage control function
AutoBlock Disabled
Enabled
- - Disabled Block of the automatic mode in voltage
control function
FSDMode Disabled
Auto
AutoMan
- - Disabled Fast step down function activation mode
tFSD 1.0 - 100.0 s 0.1 15.0 Time delay for lower command when fast
step down mode is activated
Vset 85.0 - 120.0 %VB 0.1 100.0 Voltage control set voltage, % of rated voltage
VDeadband 0.2 - 9.0 %VB 0.1 1.2 Outer voltage deadband, % of rated voltage
VDeadbandInner 0.1 - 9.0 %VB 0.1 0.9 Inner voltage deadband, % of rated voltage
Vmax 80 - 180 %VB 1 105 Upper lim of busbar voltage, % of rated voltage
Vmin 70 - 120 %VB 1 80 Lower lim of busbar voltage, % of rated voltage
Vblock 50 - 120 %VB 1 80 Undervoltage block level, % of rated voltage
t1Use Constant
Inverse
- - Constant Activation of long inverse time delay
t1 3 - 1000 s 1 60 Time delay (long) for automatic control
commands
t2Use Constant
Inverse
- - Constant Activation of short inverse time delay
t2 1 - 1000 s 1 15 Time delay (short) for automatic control
commands
t_MinTripDelay 3 - 120 s 1 5 Minimum operating time in inverse mode
OperationLDC Disabled
Enabled
- - Disabled Operation line voltage drop compensation
OperCapaLDC Disabled
Enabled
- - Disabled LDC compensation for capacitive load
Rline 0.00 - 150.00 ohm 0.01 0.0 Line resistance, primary values, in ohm
Xline -150.00 - 150.00 ohm 0.01 0.0 Line reactance, primary values, in ohm
LVAConst1 -20.0 - 20.0 %VB 0.1 0.0 Constant 1 for LVA, % of regulated voltage
Table continues on next page
1MRK504116-UUS C Section 3
IED application
701
Application manual

Table of Contents

Other manuals for ABB RET670

Related product manuals