17
120
17 - Operator panel
17�3�2 Acknowledging alarms
The operator panel has an alarm LED that corresponds
to the alarm LED on the WMPro. It ashes if there are any
alarms waiting to be acknowledged, and stays constantly
lit if there are active alarms that are not waiting to be
acknowledged.
You can acknowledge all alarms by pressing Reset. This does the same thing as "Acknowledge all" in
the web interface. You will need to press OK to conrm. You are then prompted to enter the pass-
word unless you have already done so.
Just like the web interface you are prompted to enter a sig-
nature. The signature is up to three characters long. Press
the up and down arrows to change the character. Press
the right and left arrows to select the character you want
to change. Press OK when you have entered the correct
signature.
17�3�3 Active alarms
You should obviously not acknowledge an alarm unless
you know what the problem is, you can use the Active
alarms menu to nd out. Use the up and down arrows to
move to the menu, then press OK.
You can press the up and down arrows to browse through
all active alarms (if there are any). The top line in the dis-
play shows the alarm status, with the name underneath.
The arrow in the bottom right indicates that you can press
the right arrow for more information. This display shows
the time and date when the alarm was triggered.
If the selected alarm is active, you can press Reset to ac-
knowledge this particular alarm.
If the alarm does not require acknowledgement or if it has
already been acknowledged, you will see a message. Oth-
erwise the process is the same as "Acknowledge all".
Alarms
When an alarm occurs, the opera-
tor panel immediately displays the
active alarm. Press Esc to exit this
mode, or Reset to acknowledge.
Acknowledge all?
[Esc]=NO, [OK]=YES
Signature?
_
Alarm: Active
Deviation radiator>
2005-04-07 14:34:56
<
To Next Page
Loading...
Need help?
General