7
59
7 - Alarms
Name Description
*** ALL *** Someone has clicked the "Acknowledge all" button.
Reset The device has restarted, either after a power cut or after a restart command. For
example, a le download always triggers a reset.
Watchdog reset The device has restarted because of an internal error. Acknowledgement required.
Database error There are several possible causes. The most common problem is that the database
content does not match the denition. The error may also be caused by an over-
load. Acknowledgement required.
FLASH param error The device has detected an error in some of the settings stored in ash memory.
These settings may have been changed to the default settings. Acknowledgement
required.
EEPROM param error The device has detected an error in some of the settings stored in EEPROM. These
settings may have been changed to the default settings. Acknowledgement re-
quired.
FLASH param init The settings in ash memory have been changed to the default settings, either in
response to a command or after a software update. Acknowledgement required.
EEPROM param init The settings in EEPROM have been changed to the default settings, either in re-
sponse to a command or after a software update. Acknowledgement required.
RAM corrupt Error detected in RAM. The device has restarted, No action is necessary unless the
error keeps occurring. Acknowledgement required.
Ethernet error Error in Ethernet communication. If the error keeps occurring, you will need to
replace the device. Acknowledgement required.
Program error The device has restarted because of a software error. Make a note of the circum-
stances around the time the error occurred, and send the system log le to Abelko.
If the error occurred some time ago, the information about the error is likely to
have disappeared from the system log.
Clock error Error reading from or writing to the real time clock. The error may occur if the
WMPro has been switched o for a long time. Check the clock settings. If the error
keeps occurring there is probably a hardware error. Acknowledgement required.
File upload error A fault occurred during a le upload to the device. Either the upload was interrupt-
ed, there was a le error, or the le type was wrong. Acknowledgement required.
New program New software has been uploaded to the device, and it is working. Acknowledge-
ment required.
Email error An error occurred while trying to send an email. Possible causes include incorrect
settings or a communication problem. If the device later succeeds in sending the
message, the error is reset. Acknowledgement required.
Email test A test email has been sent.
SMS error An SMS text message could not be sent because of an error.
SMS test A test SMS has been sent.
SMS max limit error SMS text messages were not send because of the function intended to limit costs.
See section 3.8.
To Next Page
Loading...
Need help?
General