161
8
Error E4: OCCLUSION
w WARNING
If the Error E4: OCCLUSION occurs, immediately check your
blood glucose level, and then check again about two hours
later, as insulin delivery has been interrupted. If your blood
glucose level is high, take appropriate action according to
your doctor’s or healthcare team’s instructions.
Insulin was not delivered. This may be due to:
j a blocked infusion set
j a damaged cartridge
j a dirty or damaged piston rod
If an Error E4: OCCLUSION (blockage) occurs, follow the
steps listed below:
j Press f twice to turn off and to conrm the Error.
j Disconnect or remove the infusion set from your infusion site.
j Change the infusion set and prime it, as explained in chapter 2.
j Put your pump in RUN mode.
To Next Page
Loading...
