Accutome A-Scan Plus Connect - Measurement, Calculation, and Reporting

30
Accutome A-Scan Plus Connect User’s Guide
How to Take a Patient Measurement
1. Select OD/OS.
2. Select eye type. This is done by opening the drop down window next
to the eye type. The system defaults to phakic and is ne for most
cataractious eyes. If measuring an aphakic, pseudophakic, or other eye,
the eye type must be set accordingly.
3. Click on contact or immersion.
4. Select the display range by selecting normal, extended or max. Normal
should measure all but the longest of eyes.
5. If you are using the automatic mode, the Accutome A-Scan Plus Connect
will automatically freeze when the minimum lock on criteria is met.
6. When manual capture is used, depressing the foot switch freezes the
image on the screen. Depressing the foot switch again will reactivate the
probe to measure.
Note: The user must review the auto measurement for quality. For more
information on taking measurements, refer to the “Performing Measurements”
section of this manual.