ACO 6236 - Content of CD-ROM; Installation of the Data Management Software

5
1.3 Installation of the Data Management Software
Before installation of the Data Management Software, log-in to the Windows XP (SP2 or higher),
Vista, or 7, by the account that has “administrative rights” or “Administrator”.
If the Data Management Software was previously installed, it shall be uninstalled before the
new installation. Explanation as shown below is for the case of Windows XP.
1.3.1 Content of CD-ROM
Following files are stored in the CD-ROM for the Data Management Software.
CDM 2.06.00 WHQL Certified --------- 【USB Driver】 folders
amd64
i386
CMD 2 06 00 Release Info.rtf
ftd2xx.h
ftdibus.cat
ftdibus.inf
ftdiport.cat
ftdiport.inf
LogoVerificationReport.pdf
NA-0038M ----------------------------------- 【TYPE 6236 Data Management Software】 folders
DotNetFX35
Windows Installer 3_1
setup.exe
Type6236AssSetup.msi
Instruction Manual for Data Management Software NA-0038M.pdf
aco_auth.lic ---------------------------------- 【Authentication File 】
(only when the software is purchased through
correct route)