Copyright
©
2005 ACTIA - How to Use SmarTach
®
- Advanced Functions - 33
English
2. Press or as many times as necessary to go to
COMPANY.
3. Press to select COMPANY.
4. Press or as many times as necessary to
select REMIND BEEP.
5. Press to select REMIND BEEP:
6. Press or as many times as necessary to
select REMIND BEEP condition:
• when ignition is turned on.
• when ignition is turned off.
7. Press to validate the selected condition.
8. Press to validate the change or to exit without
change.
In the following example, press to choose REMIND
BEEP when ignition is turned off.
9. The change is taken into account.
10. The last selected main screen appears.
4.2 How to Reset the Tripmeter
You may reset the vehicle tripmeter, unless the workshop has
deactivated this function.
To reset the tripmeter, proceed as follows:
1. The vehicle tripmeter can be displayed when:
• you press or as many times as necessary
in the first level of menus to select the adequate display.
2. Press to reset the tripmeter.
To Next Page
Loading...
