Copyright
©
2005 ACTIA - Appendices - 69
English
17. In the event of loss, theft, damage to or defective operation
of his card, the driver shall, at the end of his journey, print out
the information relating to the periods of time recorded by
SmarTach
®
and mark on this document the details that
enable him to be identified (driver card number and/or name
and/or driving licence number), including his signature.
18. The driver may continue to drive without his driver card for a
maximum period of 15 calendar days or for a longer period if
this is necessary for the vehicle to return to its premises.
6.2.2 Conditions for Secure Use
SmarTach
®
can only be used reliably, that is in compliance with
its security objectives, if the following conditions apply:
1. SmarTach
®
must not be unpowered.
2. The SmarTach
®
housing must not be opened by its users.
For this reason, SmarTach
®
has 5 tamper-protection labels
including 2 red ones on the sides of the front panel. It is
strictly forbidden to remove these labels.
3. Drivers must make certain that SmarTach
®
internal UTC time
corresponds to the real time.
4. Drivers must only use models of paper roll type approved for
SmarTach
®
.
5. Drivers must not introduce cards other than their own into
SmarTach
®
.
6. Each driver must only have one valid card at any given time.
7. Periodic inspections of SmarTachs
®
installed on vehicles
must be made after each repair, after each change in
characteristic coefficient of the vehicle, or in the effective
circumference of the wheel tyres, when deviation of the UTC
clock exceeds 20 minutes, or when the vehicle registration
number has changed, and 2 years at the latest after the last
inspection.
8. Drivers must use SmarTach
®
as provided for by the
regulations and instructions explained in this manual, and
behave responsibly.
To Next Page
Loading...
