Chapter 10 - System Operation
146 Adept Python Modules User’s Guide, Rev. E
Load and Run DC_SETUP.V2
This section goes through the MB-10 initialization. You identify and configure each axis in
your system during this process. Type the following at the prompt.
load d:\util\dc_setup.v2
execute 1 a.dc_setup
1. The first screen in the Setup program looks similar to Figure 10-1. Select
“Configure Modules/Servo Kits/Hybrid.”
Figure 10-1. DC_SETUP Program Main Screen
2. In the next screen, select “Modules quick setup.”
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...