Menu Descriptions
61179641L4-5B 5-73
SNMP Community Names Menu
SNMP Community Names
Main Menu\System Management\SNMP/TL1 Configuration\SNMP Community Names\
The SNMP Community Names menu (see Figure 5-46) is used to establish up to three named
accounts which specify unique IP addresses and privileges for network management. To
restrict SNMP remote access to a single IP Address, assign the IP Address to a community. An
IP Address of 0.0.0.0 allows access from all IP Addresses.
Figure 5-46. SNMP Community Names Menu
The SNMP Community Names menu options are shown in Table 5-46.
Table 5-46. SNMP Community Names Menu Options
Option Description Function
1 Name This option is used to configure the first SNMP
community. Settings include private and public.
2 IP Address This option is used to configure the first SNMP
community IP address in decimal dot format (i.e.,
###.###.###.###).
3 Privileges This option is used to configure the first SNMP
community privilege level. Options include Read/Write
and Read.
4 Name This option is used to configure the second SNMP
community. Settings include private and public.
TID: TA1248 Total Access 1248
Unacknowledged Alarms: None
SNMP Community Names
Set Name to 0 to delete Community
1. Name private
2. IP Address 0.0.0.0
3. Privileges Read/Write
4. Name public
5. IP Address 0.0.0.0
6. Privileges Read
7. Name Not Configured
8. IP Address 0.0.0.0
9. Privileges
Selection :
'?' - System Help Screen
To Next Page
Loading...
Need help?
General
