Total Access 1248 Octal T1 IMA DSLAM Installation and Maintenance Practice
1-4 61179641L4-5B
Compliance
CAUTION
Electrostatic Discharge (ESD) can damage electronic modules.
When handling modules, wear an antistatic discharge wrist strap
to prevent damage to electronic components. Place modules in
antistatic packing material when transporting or storing. When
working on modules, always place them on an approved antistatic
mat that is electrically grounded.
The Total Access 1248 is NRTL listed to the applicable UL standards. The Total Access 1248
meets or exceeds all the applicable requirements of NEBS, Telcordia GR-63-CORE, and
GR-1089-CORE.
The Total Access 1248 is intended for deployment in Central Office type facilities, EEEs,
EECs, and locations where the NEC applies. Install the Total Access 1248 in a restricted
access location. Table 1-2 shows the compliance codes for the Total Access 1248.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by ADTRAN could void the user’s authority
to operate this equipment.
Table 1-2. Compliance Codes
Configuration Codes Input Output
Power Code (PC) F C
Telecommunication Code (TC) X X
Installation Code (IC) A –
C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
To Next Page
Loading...
Need help?
General
