Total Access 1248 Octal T1 IMA DSLAM Installation and Maintenance Practice
5-128 61179641L4-5B
Usable Usable This condition indicates that the link is ready to be used
for receiving ATM layer cells and it is awaiting the FE Tx
to be Usable or Active before moving into the Active
state.
The link has been synchronized with the other receive
links already in the Usable or Active state.
The IMA receiver considers the link to not be in a data
round-robin state.
Active Active This condition indicates that the link is capable of
passing cells to the ATM layer.
The IMA receiver considers this link to be in a data
round-robin state.
Near End and Far End Rx Failure
Failure Failure This condition indicates that a reason was not given.
LIF Loss of IMA Framing This condition indicates a loss of IMA framing.
LODS Link Out of Delay
Synchronization
This condition indicates a link out of delay
synchronization.
Misconn Mis-connectivity This condition indicates that mis-connectivity has been
found as a result of a test.
Inhibit Inhibit This condition indicates that operation of the link is
blocked for some locally defined application or
implementation dependant reason.
The link may be used for testing.
Blocked Blocked This condition indicates a transition into the unusable
state without loss of ATM layer cells.
Fault Fault This condition indicates a fault on the link or in the link
protocol.
FeTx UU Far End Transmit Unusable This condition indicates that the Far End transmitter is
in the unusable state.
FeRx UU Far End Receive Unusable This condition indicates that the Far End receiver is in
the unusable state.
NoFault No fault This condition indicates that there is no current failure
condition.
Table 5-88. IMA Link Failure Monitoring Status Screen
States and Failure Conditions (Continued)
State Definition Failure Condition
To Next Page
Loading...
Need help?
General
